|
|
|
|
|
|
| Author |
Messages |
|
DOUBLE07GT 
Posts:1
 |
| 06/24/2008 3:14 PM |
 Alert
|
INTAKE TO PAN AND ALL ACCESSORIES/LINES/FITTINGS (EVERYTHING YOU SEE IN THIS PHOTO)
All-aluminum 412" Windsor w/4-Stage dry sump system
13.1 compression
Ford Motorsport J351 9.200" deck aluminum 4-bolt main block (never hurt)
Billet screw-in freeze plugs
Yates C3 Hi-Port heads and Yates/4500 Edelbrock-Yates intake/both CNC ported by Kuntz & Co.
ARP head studs and ARP bolts/nuts on complete engine
T&D 1.7/1.8 individual shaft roller rockers
JESEL pushrods
Hellfire rings
Stealth titanium intake/exhaust valves, locs/retainers
Moroso billet rail valve covers
DannyBee belt drive
ATI Super Damper
Crane Pro Series roller lifters
55mm Cam Bearings
Cam Motion custom solid roller (have specs)
MSD Crank Trigger
Manley NexTec valve springs
MSD Crank Trigger Wide Diameter Distributor
MGP aluminum rods/AMS 6415 Crank
Ross custom gas ported pistons (extra new spares included)
Moroso and Stock Car Products 4-stage dry sump system
Moroso Dry Sump tank
Moroso Vacuum pump
Induction Solutions/Edelbrock twin annular foggers by Steve Johnson w/tune-ups/jetting maps
Induction Solutions custom Holley nitrous fuel regulators and fuel log
Nitrous wiring is done in weatherpacking
Meziere Billet water pump.
STEF's custom aluminum billet rail dry sump oil pan (made for Fox Body tubular K-member)
JW The Wheel SFI flexplate with ARP bolts
Moroso Vacuum System relief valve
All Aeroquip fittings and lines throughout
Product Engineering Carb Regulator
Two sets of sparkplug wires (MSD and FireCore)
Billet carb mounted Throttle cable bracket
Competition Motorsports custom wide-open throttle nitrous switch
9.50's @ 145 (on motor) and 7.80's @ 175-179 (nitrous) w/1.18 60-ft on 29.5 tire @ 3050# in a Fox Body Mustang. Sold my car 2-months ago as a complete roller, so no use for the motor.
Motor has an HONEST 6-passes (motor only) since freshen-up and 1-nitrous pass that was aborted due to wheel stands during that particular pass. Rotating assembly, cylinder head hardware only have 7-total passes since refresh.
Done racing for a while, I just do not have time for it anymore with busy work/family life.
Motor has never been hurt and is ready to go. $13K or best offer, no reasonable offer refused. Serious only please. Will build wooden crate and assist with shipping arrangements, unless you come get it.
SOLD! SOLD! SOLD! |
|
|
|
|
|
| You are not authorized to post a reply. |
|
|
|
ActiveForums 3.6
|
|
|
|